H FT-DX1200 OPERATOR'S MANUAL Page 7

FTDX1200 Operating Manual Page 7

BEFORE YOU BEGIN Cont'd
Previous Page    Index of Topics    Table of Contents    Index of Pages    Next Page
ADJUSTING THE CLOCK
Use the following procedure to adjust the clock shown at the middle right of the TFT display.

   1. Press and hold the [C.S.] until the clock
        digits blink.

   2. Enter the present time with the number
        keys ([BAND] keys).

   3. Press the [ENTER] button.


End of "Setting the Clock"


RESETING THE MICROPROCESSOR

RESETTING MEMORIES (ONLY)

Use this procedure to reset (clean) the previously stored Memory channels, without affecting any configuration changes you may have made to the Menu settings.

   1. Press the front panel [POWER] switch to
        turn the transceiver off.

   2. While holding the [A►M] button in, press
        and hold in the front panel [POWER]
        switch to turn the transceiver on. Once the
        transceiver comes on, you may release the
        buttons.

MENU RESETTING

Use this procedure to restore the Menu settings to their factory defaults, without affecting the memories you have programmed.

   1. Press the front panel [POWER] switch to
        turn the transceiver off.

   2. While holding the [MENU] button in,
        press and hold in the front panel
        [POWER] switch to turn the transceiver
        on. Once the transceiver comes on, you
        may release the buttons.

FULL RESET

Use this procedure to restore all Menu and Memory settings to their factory defaults. All memories will be cleared by this procedure.

   1. Press the front panel [POWER] switch to
        turn the transceiver off.

   2. While holding the [FAST] and [LOCK]
       buttons in, press and hold in the front panel
        [POWER] switch to turn the transceiver
        on. Once the transceiver comes on, you
        may release the buttons.

IMPORTANT NOTE:
When the optional µTuning Kit is connected to the FTDX1200, disconnect all the cables from the µTuning Kit before performing the Full Reset.













End of "Resetting the Microprocessor"

End of "Before You Begin"
Previous Page    Index of Topics    Table of Contents    Back to Top    Index of Pages    Next Page
FTDX1200 Operating Manual

Page 7